Hydraulic kit for Carson crawler loader + rear ripper 1580.00 €
FINANZIERUNG | ||
---|---|---|
6 Monate | = | 269.22 € |
12 Monate | = | 137.17 € |
24 Monate | = | 71.19 € |
36 Monate | = | 49.25 € |
48 Monate | = | 38.31 € |
60 Monate | = | 31.75 € |
72 Monate | = | 27.43 € |
Alle Angaben monatliche Rate ohne Anzahlung. Ein Angebot der Santander Consumer Bank. Eff. Jahreszins zur Zeit 7,90%. Bonität vorausgesetzt. Keine weiteren Kosten.
New from Leimbach Modellbau is a conversion kit for the CARSON loader to operate with hydraulics, incl. ripper hydraulics. The conversion kit contains, among other things, a lever, especially on the tilt cylinder of the hydraulic kit is adapted to both a vehicle with the crawler as well as a hollow standing on the ground to load optimally.
Due to the limited space available in the crawler loader only relatively thin cylinders are installed. Nevertheless, the necessary power for earth movements to reach is the operating pressure of the Hydraulic set to approx. 15 bar preset.
Technical specifications
- Pump motor: brushless
- Operating voltage: 7.4 V (2-cell LiPo)
- Current consumption (hydraulics): approx. 4.5 A
- Operating pressure: 15 bar
- lifting capacity: approx. 2kg (with shovel)
The rear ripper is not included!